How To change chain and rear sprocket..

700Rappy · 07-21-2008, 04:30 PM

ok guys i managed to change my rear sprocket and chain so im going to do a how to..

Tools needed:
1. atv jack, Ratchet, 14mm socket, break bar if needed, flat head screw driver,allen keys,dw-40, loc tight.

Directions:

1.Put bike in neutral with parking break on..
2. Knock the 4 bolts holding the sprocket on loose...i had to use some DW-40 to help loosen mine..
3..Jack up bike and take tire off
4. slide the rear sprocket off..
5. put new sprocket back on..make sure to loc tight bolts to ensure they dont rattle off
6. torque to specs as per service manual..(will check when i get home)
7.At this point your going to want to put your chain on..
8.I replaced the front sprocket as well so i put a new chain on also... installed master link
9. make sure to have your swing arm totally loosened for slack in chain so you can tighten it back up after for adjustments. you do this by loosening the 4 axle allen nuts in sequence.

front sprocket torque specs : 61 ft.lbs
rear sprocket torque specs:
approx..1- 1.5 " of chain slack is ideal..

07-21-2008, 04:30 PM	#1 (permalink)
700Rappy Modding the Motor Join Date: May 2008 Location: Timmins Ontario, Canada Posts: 265	How To change chain and rear sprocket.. ok guys i managed to change my rear sprocket and chain so im going to do a how to.. Tools needed: 1. atv jack, Ratchet, 14mm socket, break bar if needed, flat head screw driver,allen keys,dw-40, loc tight. Directions: 1.Put bike in neutral with parking break on.. 2. Knock the 4 bolts holding the sprocket on loose...i had to use some DW-40 to help loosen mine.. 3..Jack up bike and take tire off 4. slide the rear sprocket off.. 5. put new sprocket back on..make sure to loc tight bolts to ensure they dont rattle off 6. torque to specs as per service manual..(will check when i get home) 7.At this point your going to want to put your chain on.. 8.I replaced the front sprocket as well so i put a new chain on also... installed master link 9. make sure to have your swing arm totally loosened for slack in chain so you can tighten it back up after for adjustments. you do this by loosening the 4 axle allen nuts in sequence. front sprocket torque specs : 61 ft.lbs rear sprocket torque specs: approx..1- 1.5 " of chain slack is ideal.. __________________ 2006 700r Pro Circuit Ti4 Exhaust Cobra Fi2000r fuel controller Custom Made Tephlon Case Saver 15t Renthal Velocity Air Intake Kit Crj +2.5 Wheel spacers ITP holeshot HD's rear ITP Holeshot STD on C series rims DG Front Bumper DG 6 pack rack Motosport Nerf bars Fly Bars Last edited by 700Rappy; 07-25-2008 at 07:13 AM. Reason: how to

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode