Few weeks ago I was super excited to get my new Maxxis RAZR's. I had a dealer put them on the rims for me but I put the finished product on my 2001 Raptor 660. The night before I partied with a few friends, a little too hard than I probably should have. Long story short when I put the wheels on I was pretty tired. I hand wrenched the lug nuts on as tight as I could but apparently it wasn't enough for the rear left. I was riding today and noticed that tire was wobbling although I didn't feel it since I was on dirt. I immediately drove home to check it out. I kicked the wheel a bit and it was loose I checked out the rim where the nuts once were and they were gone. I was left with the rims and a big line on each hole where the lugs slide in. I don't know how to explain it any better so heres a pic. SSN5475.jpgSSN5475.jpg All I ask is that if I put brand new lug nuts on will it be safe to operate? Thanks!
"Clutch is the only way to brap"
01 Raptor 660R
FMF Carb Jet Kit (needles unknown)
HMF Competition Series Trimax Core Full Exhaust
Lone Star Racing Sport Extended A-Arm
Custom (forgot name) extended rear axle
UNI Air Filter
Trail Tech Vapor (tach, speedo, temp guage...)
DWT RCR V1 Tires w/ Beadlocks
Black Path Racing rear bearing and bearing carrier.