Modded Raptors Forum banner

idle

  1. 2005 Raptor dying at idle after some hard-riding

    Raptor 660 General
    Hi Folks My raptor seems to be dying at idle after being ridden very hard -under normal riding conditions it idles fine without any problems. After dying it takes a few turns of the starter for the motor to run. My initial thoughts was that it was overheating but when checking the rad-fan I...
  2. Need Map/Advise for PCV

    Raptor 700 Mods
    Hey guys I finally got the big 3 on my rappy and now I downloaded some premaps from PCV website that was the closest to my setup and was wondering if anyone had anything better or closer, I'm running K&N with Outerwears, PCV reg version and a Yoshimura rs2 and no air box, it still at times wants...
  3. Raptor 700 dying at idle after new rs-2 slip on exhaust

    Raptor 700 Maintenance
    Hey guys I just recently bought a Yoshimura Rs-2 slip on exhaust on my 2011 raptor 700, and was told I didn't have to remap it because its only a slip on. So now when I start it occasionally it will start sound fine for about 30 secs then die, but if I give it a rev or 2 it runs/sounds fine...
  4. Cranking down the idel screw?

    Raptor 700 General
    Has anyone ever tryed to turn there idle up real high? Can it even be done? I've tryed turning the screw on the throtle body in to get high idle but it only goes up a little bit. I turned it in about 10 turns. The reason I'm trying to do this is to do a no handed wheelie. On my Warrior I can...
Top