I ordered a power command v for my 07 raptor 700. I followed the instruction for the wiring and I turn the key to start it, fuel pump primes it and runs for 1 second then dies right away or it wont start at all. I am lost and don't know what to do. any help would be greatly appreciated.
Hey everyone. bad news my 2009 se was stolen last week so im back to square one. Im going to look at a 2008 SE on saturday that is completely stock and from what im told has only had about 6 tanks of gas through it.
From the pics the bike appears to be very clean. Im looking to start with the...
Hey guys couple questions.
I have acustom 2009 Raptor
Engine: (stock bore and stroke)
12:1 cp piston
Port and polished head
Stage 3 hot cam
Dmc dual afterburner exhaust
k&n pro flow velocity intake
trinity stage IV programmer
Billet engine cooler.
Sorry for these noob questions but...
I am looking for a map for my 06 raptor running PCV
mods for now are
Trinity stage 4 full exhaust
airbox lid on
riding in sand at sea level mostly duning/ dragging
any help would be greatly appreciated!!
I got a pcv and it's dumped raw fuel in my oil after dyno tune dealer is fixing it and recommending a auto tune due to my harsh conditions and fci without kid I have on my bike......what does a auto tune do?also is a dynatek programable and coil gnna help anything?and does it have a rev...
I'm not sure if I'm doing this wrong or not, I'm new at this, so please cut me a little slack ;)
I just dumped my dobeck TFI and ordered a PCIII
I'm needing a map for the following:
DMC afterburner comp4 duals
no airbox lid
modquad intake/k&n filter
Hotcam stage 2
I installed everything lastnight and when hooked up to the laptop, It reads RPM's, but NO Air/Fuel Ratio...Anyone experience this?
Also, I ran it 3 times for 15-20 minutes each and seen only one change.
Does anyone have or know of a right up about this software and tips with using...