Search Results for ‘power commander’

Hey guys I finally got the big 3 on my rappy and now I downloaded some premaps from PCV website that was the closest to my setup and was wondering if anyone had anything better or closer, I'm running K&N with Outerwears, PCV reg version and a Yoshimura rs2 and no air box, it still at times wants...

Hey guys, I can't seem to get my fourwheeler tuned right.does anyone know any one in the east Tennessee area that can help me tune my bike properly?or a shop to take it to?it's backfireing and cutting in and out.it seems weather affects it alot.I thought maybe fci would act up in cold weather...

Hey guys my dealer says I need a new dyno tune everytime we transition from summer to winter and back.also in a 700 how do you check your oil?when I picked it back up today I rode a wheelie across their parking lot.....the dealer said wheelies will harm my crank?also will an fci with box and...

Hey guys I'm picking up a tether switch ambush tires fci with box powe commander v and Phoenix exhaust insert along with a Barnett dirt digger clutch.....how will this do for dusty muddy trails?also how much speed and power will I gain?

Well guys this is my first post and I have a 2009 raptor 700r se.it was bought new by me three months ago and has a little under 2000 miles.the bottom end of my motor rattles horribly when I rev the motor medium to high rpms?any idea why?also I changed my oil and it had gas in it and spark plug...

I hate making posts like this, but I need your guys' help. I'm needing a map for my PCIII. Mods are: DMC afterburner duals Modquad intake/no lid/k&n +3 TB 11.5:1 piston HC2 PC3 Dynatek programable ign. If anyone has anything that would get me close, PLEASE help a brotha out. For my side of...

I'm needing a couple maps to try out again if anyone would happen to have any they think may get me close. My elevation: 200 ft. Mods: DMC afterburner comp 4 duals no lid/quadworks intake/k&n bored +3 tb 11:1 CP piston PCIII Dyna FS programable ign Hotcam STAGE TWO I've also got a few maps...

Hey im looking for a taillight and a pc3... shoot me an email or pm me. [email protected] Thanks

I'm not sure if I'm doing this wrong or not, I'm new at this, so please cut me a little slack ;) I just dumped my dobeck TFI and ordered a PCIII I'm needing a map for the following: Elevation 200ft DMC afterburner comp4 duals no airbox lid modquad intake/k&n filter Hotcam stage 2 PCIII If...

Hi guys, I installed everything lastnight and when hooked up to the laptop, It reads RPM's, but NO Air/Fuel Ratio...Anyone experience this? Also, I ran it 3 times for 15-20 minutes each and seen only one change. Does anyone have or know of a right up about this software and tips with using...