Modded Raptors Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
228 Posts
Discussion Starter #1
hey does anyone know the width, hieght and pull back of stock raptor 700 handle bars?? thanks in advance.
 

·
Registered
Joined
·
5,414 Posts
......there are a few companies the make stock replacement bars with FACTORY BENDS.... if thats what u are looking for.....got a stock set to get rid of myself
 

·
Registered
Joined
·
228 Posts
Discussion Starter #3
i was more looking at where my hands would be positioned with the aftermarket bend campaired to stock. but i think im just going to go with a nice set of risers for now. (until i bend up my stockers)
 

·
Registered
Joined
·
5,414 Posts
i just installed a complete TRAILTECH set up with their HIGH BEND "X" bars and bar clamp/riser....these bars are aluminum 1 1/8 and sit 1/2 taller then stock when used with their bar mount.....and looks awesome....i also added their VAPOR computer to top it off....
the x bars have a great feel to them and are atv specific
 

·
Registered
Joined
·
5,414 Posts
comes with a bracket...u can either mount in between the barn and the tank with the vapor or on the outside............all CROME!!!
sorry, i dont have pics for u.....dont have my camera this week...loaned it out
 

·
Registered
Joined
·
228 Posts
Discussion Starter #7
all good sounds like a sick setup though! sigh to bad i need new rear tires b4 i can buy some mods.
 
1 - 7 of 7 Posts
Top