Modded Raptors Forum banner

1 - 20 of 70 Posts

·
Registered
Joined
·
203 Posts
Discussion Starter #1 (Edited)
Started building a hill Raptor for a customer of mine, and he wants to put LT on his Teryx so I'm going to sell this stuff for him. PP accepted as a gift only, located in Tucson. Can meet in Phoenix or Vegas with parts. Prices do not include shipping.

PayPal: [email protected]

New Parts:

105 steel sleeved cylinder and Kenz piston, both new, gasket kit- 550

EKO Ti arched ladder bar +8- 1600...retail is 2000

Pivot Works swingarm bearing and seal kit- 60

Used Parts:

Coil with yellow wire- 50
Gas tank with fuel pump and Blingstar cap- 75

Linkage- 40

Bottom end with HR +5 crank, balanced for 105, Slingshot, oil tank, Blingstar covers. Motor broke a valve, and I would suggest having CW check the rod....1000.
 

·
Registered
Joined
·
203 Posts
Discussion Starter #3
Will not separate frame or subframe as they are both PC Satin Black. All PMs returned.
 

·
Registered
Joined
·
203 Posts
Discussion Starter #13
All pics sent.

Please don't waste my time on this deal.

Not going to budge on the EKO parts.

The axle is 4/115, Honda sprocket, 700 brake. It is a blem. The shaft is perfect, the only scratches are on the hubs. I laughed at what they consider a blem hub. Axle still carries the lifetime warranty.
 
1 - 20 of 70 Posts
Top