Modded Raptors Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I've got the cylinder off my 660 and it needs to be cleaned up. But what's the best way to hone it for a new wiseco piston and rings? Which grit would be best for the cylinder?
 

·
Registered
Joined
·
66 Posts
I use Flex Hone 120 Grit. Make sure you use a lubricate like wd40, with a flex hone attached to a drill move the hone up and down fast. What you want is a cross hatch about 45 degree or so. Shouldnt take more then 30 second to hone. Hope this help.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top