Modded Raptors Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
182 Posts
Discussion Starter · #1 ·
OK, well I bought some led lights in hopes of using them to install a custom tail light. I have a stock pig tail from the old tail light and I connected the (4) LED's to the wires and my plan was to have 2 on as running lights and have 2 turn on when the brakes are applied but the problem is that the lights stay on constantly even when applying the brake.....What am I doing wrong? I believe there is a Blue wire, a Yellow, and a black, I connected 2 (+) terminals of the LED's to the Blue wire and 2 (+) wires to the Yellow wire then all 4 (-) wires to the black(Ground) wire. Is there something I am missing? Do I need to have dual filament bulbs for this to work?
 

·
I am smarter than you....
Joined
·
2,051 Posts
you need to pin it out and see what it does. did it come with a wiring diagram when you bought the lights? you might also have a short somewhere causing power to be on the brake light wire all of the time. do they turn off when you dont have the head lights on?
 
1 - 4 of 4 Posts
Top