Modded Raptors Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
93 Posts
Discussion Starter #1
pro design intake with foam filter,pc111,and sparkarrester out give me noticably more power? thanks
 

·
Registered
Joined
·
2,177 Posts
ive herd it will. i first did the pc3 pro designs K&n intake and a white brother single exhaust and it was a huge difference.
 

·
Registered
Joined
·
93 Posts
Discussion Starter #4
well, i ordered this setup for 520 shipped,and its not the full exaust.just a slip on. did I get ripped off? and will it give here some better power. and the FI controler is already setup for this with the lid off.

 

·
Registered
Joined
·
2,853 Posts
it will give you more power for sure.. not the route i would of went.. if your going to put on an exhaust you should go full system.. a slip on is just a little better then pulling the sparky out.. just my 2 cents.. but you will notice a good change in the power.. :thumb:
 

·
Registered
Joined
·
253 Posts
PCiii, Dyna Ignition, +2 mm Throttle body, Stage3 cam, Barkers, GYT-R intake almost 60HP.
 
1 - 8 of 8 Posts
Top