[kgwmu]

Anybody know what the length is center to center on a stock swinger? I am not by my bike so I can't measure.

Thanks,
Kevin

 

[phucker]

center of the mounting bolt to the center of the axle?

 

[kgwmu]

center of the mounting bolt to the center of the axle?

yes that is what I was asking about. I should have been more specific. :beerchug:

 

[phucker]

ok i will get it for you as soon as i can get my lazy ass outside.

 

[kgwmu]

ok i will get it for you as soon as i can get my lazy ass outside.

sweet, thanks man :rockon:

 

[phucker]

hahaha oops, i just went out to measure it and i have a plus 4. sorry i cant give you the exact dimensions

 

[kgwmu]

hahaha oops, i just went out to measure it and i have a plus 4. sorry i cant give you the exact dimensions

can you tell me what the +4 dimension is? then I will be able to figure out what stock is.

 

[phucker]

ya its 21 inches from pivot bolt to axle

 

[SEVEN00]

OOPS, FORGET IT!

 

[phucker]

well my measurement is within a quarter of an inch. i just never measured the metal i had cut for me. it is very close to being 4 inches

 

[SEVEN00]

is this a 700 phucker or a 660?