Modded Raptors Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter · #1 ·
I am in need of a 660 motor with a good tranny. I belive my tranny is about to take a crap, and i would rather just swap motors and be done with it. if anyone has one let me know a price and where you are located. The closer to ohio the better
 

·
Registered
Joined
·
91 Posts
i have a complete bottom end with a 4 mill barker crank. i just went through tranny and replaced 2nd and 2nd pinion 1 hr on it also new shift shaft. 800 bucks with out covers. the crank lets you run stock pin height with stock bore itll make it a 690.950 with polished covers and water pump. has l&A 1 way starter gear and hd barnett clutch and springs. shipped lower 48
 

·
Registered
Joined
·
38 Posts
2001 Yamaha Raptor 660 complete motor bolt and go

This is a complete stock motor off a 2001 Raptor 660. I bought the bike for parts and don't need the motor. I rode it after I bought it and it rode strong and shifted good. The guy that owned it before tore it down 6 months ago and rebuilt the transmission, and put new rings on the piston. i'd like to get 1200.00 plus shipping out if it.
Thanks Keith
 
1 - 4 of 4 Posts
Top